QUALITY MANAGEMENT SYSTEM
|
|
Isover products are manufactured according to ISO 9001:2008.
|
FEATURES & BENEFITS
|
- Life long energy savings
- Lightweight & easy to handle
- DIY friendly
- Maintenance free
- Long product life-will not readily age
- Suitable for high humidity applications
- Zero ozone depleting potential(ODP)
|
FIRE PROPERTIES
|
Geyser blanket:
- Non-combustible - tested to SANS 10177 Part 5
- Class 1 fire index rating - tested to SANS 10177 Part 3
- Class A1, s1, do according to EN 13823
- Tested to ASTM E-84
- Flame Spread Index: 20
- Smoke Development Index: 5
Pipes:
- Class 1 fire index rating tested to SANS 10177 Part 3
|
THERMAL PROPERTIES
|
|
Contributes to life long savings by reducing heat loss through the geyser &
associated piping due to the inherent thermal insulation properties.
|
APPLICATIONS
|
Geyser & pipe insulation for:
- Domestic
- Commercial
- Public sector buildings
|
DURABILITY
|
- Odourless, inert and fully compatible with all standard building materials & components
- Will not promote corrosion of steel, copper or aluminium
- Will not sustain vermin
- Will not breed or promote fungi, mould or bacteria.
- Non-hygroscopic
|
PHYSICAL PROPERTIES (Click on Image to enlarge)
|
|
TOOLS NEEDED FOR INSTALLATION
|
|
A sharp blade may be needed for cutting.
|
INSTALLATION INSTRUCTIONS
|
1. Wrap the entire geyser - ensure the foil is facing the outside.
2. Secure the blanket with the binding tape supplied and cut off excess.
3. Close the ends and tape down.
4. Install pipe insulation around pipes to and from the geyser (mitre cut pipe sections
around bends).
|
HANDLING & STORAGE
|
|
Store product undercover, and in dry conditions. Store flat. Handle with care, especially
on the edges and corners, which can be damaged if subject to sharp or heavy impact.
Do not apply excessive pressure, for example by standing or sitting on the product,
as permanent damage may be caused.
|
ARCHITECTURAL SPECIFICATION
|
|
Install 50 mm thick, non-combustible, lightweight Glasswool “Geyser Blanket” around
geyser or hot water cylinder. Seal edges with duct tape. Apply 2 m of 20 mm thick
“Snap-on Pipe” insulation on the incoming cold water pipes and insulate all outgoing
hot water pipes.
|
Isover reserves the right to alter or amend product specification without notice.
The information given in this publication is correct to the best of our knowledge
at the time of publication. Whilst Isover will endeavour to ensure publications
are up to date, it is the users’ responsibility to check with us that it is correct
prior to use.
|